Coupling Rod, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Before starting the procedures, determine the curb weight position. Refer to VEHICLES WITH COIL SPRINGS, CHECKING THE CURB WEIGHT POSITION FOR AXLE ALIGNMENT .
-- If equipped, remove the transverse link stone chip protection. Refer to TRANSVERSE LINK STONE CHIP PROTECTION, REMOVING AND INSTALLING .
- When loosening or tightening the coupling rod threaded connection to the stabilizer bar, counterhold on the respective coupling rod stud to prevent it from rotating.
- The counterhold tool must not be tilted.
-- Remove the nuts -1 and 3- and the bolt -4-.
-- Remove the coupling rod -2- from the stabilizer bar and transverse link.