Drive Axle, Bolted, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Before starting the procedures, determine the curb weight position. Refer to VEHICLES WITH COIL SPRINGS, CHECKING THE CURB WEIGHT POSITION FOR AXLE ALIGNMENT .

-- Loosen the drive axle threaded connection. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

-- Remove the wheel. Refer to WHEELS AND TIRES .

-- Remove the coil spring. Refer to SPRING, REMOVING AND INSTALLING .

-- Remove the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .

-- Vehicles with level control system sensor: remove the bolts -1- and free up the lever -2- for the rear level control system sensor.

Courtesy of AUDI OF AMERICA, LLC

-- If equipped, remove the transverse link stone chip protection. Refer to TRANSVERSE LINK STONE CHIP PROTECTION, REMOVING AND INSTALLING .

-- Remove the nut -3- and the bolt -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- for the tie rod -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts for the drive axle -arrows- on the rear final drive.

Courtesy of AUDI OF AMERICA, LLC

-- Tilt the wheel bearing housing outward and remove the drive axle from the rear final drive.

-- Remove the hub from the drive axle outer joint.

TIP:

If the components cannot be separated, press the drive axle out of the wheel bearing. Refer to DRIVE AXLE, PRESSING OUT OF WHEEL BEARING .