Tie Rod End, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn the steering wheel in the straight position.

-- Remove the front wheel. Refer to WHEELS AND TIRES .

-- Loosen the nut -2- while counterholding the tie rod end -1-.

Courtesy of AUDI OF AMERICA, LLC

-- To protect the threads remove the nut on the joint pin tie rod head until it is flush with the threads of the joint pin.

Fig 1: Identifying Nut Of Track Rod Ball Joint

Courtesy of AUDI OF AMERICA, LLC

-- Position the Puller - Ball Joint: T10187 -1- and press out the tie rod end from the wheel bearing housing.

-- Remove the nut on the tie rod end.

-- Remove the tie rod end -1- from the tie rod while counterholding on the tie rod hex fitting -arrow- if necessary.

Courtesy of AUDI OF AMERICA, LLC