Steering Column, Removing And Installing: Removing
-- Bring wheels in the straight position.
-- Pull the lever downward beneath steering column.
-- Push the steering column as far down as possible and remove it.
-- Remove the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Remove the footwell vent on the driver side. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR .
-- Remove the steering column switch module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .
-- Disconnect the connector -1- on the Electronic Steering Column Lock Control Module -J764- and free up the wire -arrow-.
-- Disengage the cable guide -1- from the steering column. To do so, release the tab in direction of -arrow- using a small screwdriver and unclip the cable guide from the steering column.
-- Release the lower wire holder -1- in direction of -arrows- and remove downward.
-- Set the wire for the steering column aside.
LHD Vehicles:
-- Remove the buttons -arrows-.
-- Free up the carpet in the area of the universal joint and push it slightly rearward.
RHD Vehicles:
-- Remove the footrest. Refer to FOOTREST, REMOVING AND INSTALLING .
Continuation for All Vehicles:
-- Remove the bolt -1- for the universal joint -2- and then remove the universal joint from the steering gear in direction of -arrow- (example illustration).
-- Remove the bolts -arrows- and disengage the steering column from the instrument panel crossmember upward and remove.
- Steering Column, Handling and Transporting. Refer to STEERING COLUMN, HANDLING AND TRANSPORTING .