Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Bring wheels in the straight position.
-- Pull the lever downward beneath steering column.
-- Push the steering column as far down as possible and remove it.
-- Remove the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Remove the steering column switch module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .
-- Disconnect the connector -1- and free up the wire on the bracket -arrow-.
-- Remove the shear bolts -2 and 3- using the 7/16 Inch Extractor: T10424US
-- Remove the Electronic Steering Column Lock Control Module -J764- -4-.
TIP:
If the shear bolt cannot be removed using the 7/16 Inch Extractor: T10424US , it must be drilled out using an angle drill and an 8.5 mm diameter drill bit.