Overview - SUBFRAME
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening Specification: Overview - Subframe. Refer to OVERVIEW - ASSEMBLY MOUNTS .
- Lower Bonded Rubber Bushing for Pendulum Support
- Replacing. Refer to SUBFRAME, SERVICING .
- Bolt
- 20 Nm +180°
- Replace after removing
- Install evenly
- Subframe
- There are different versions. Refer to the Parts Information.
- Securing. Refer to SUBFRAME, SECURING .
- Lowering. Refer to SUBFRAME, LOWERING .
- Removing and Installing, without Steering Gear. Refer to SUBFRAME WITHOUT STEERING GEAR, REMOVING AND INSTALLING .
- Removing and Installing, with Steering Gear. Refer to SUBFRAME WITH STEERING GEAR, REMOVING AND INSTALLING .
- Servicing. Refer to SUBFRAME, SERVICING .
- Bolt
- 70 Nm + 180°
- Replace after removing
- Not Installed
- Nut
- 65 Nm
- Replace after removing
- When tightening, counterhold on the joint pin internal multi-point bolt
- Upper Bonded Rubber Bushing for Pendulum Support
- Replacing. Refer to SUBFRAME, SERVICING .
- Stabilizer Bar with Rubber Bushings
- Removing and Installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
- Nut
- 65 Nm
- Replace after removing
- When tightening, counterhold on the joint pin internal multi-point bolt
- Suspension Strut
- Removing and Installing. Refer to SUSPENSION STRUT, REMOVING AND INSTALLING .
- Coupling Rod
- Removing and Installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Intermediate Plate
- Only for aluminum subframe
- Support
- Bolt
- 50 Nm + 90°
- Replace after removing
- Bolt
- 70 Nm + 180°
- Replace after removing