Power Rear Lid Opening Sensors -G750- / -G760-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the lower section of the bumper cover. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .

A3/S3:

Courtesy of AUDI OF AMERICA, LLC

-- Warm the adhesive using the Wiring Harness Repair Set - Hot Air Blower: VAS 1978/14A .

-- Pull off the power rear lid opening sensor -arrows- and remove.

RS3:

Courtesy of AUDI OF AMERICA, LLC

-- Warm the adhesive using the Wiring Harness Repair Set - Hot Air Blower: VAS 1978/14A .

-- Pull off the power rear lid opening sensor -arrows- and remove.