Power Rear Lid Opening Sensors -G750- / -G760-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

The lower section of the bumper cover and the power rear lid opening sensor must be at room temperature.
The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue on the lower section of the bumper cover.

-- Clean the adhesive surface of the plastic side with Cleaning Solution and let it dry.

-- Align the power rear lid opening sensor at the markings on the lower section of the bumper cover.

A3/S3: the Rear Lid Opener Sensor 2 -G760- must be secured on the lower section for the upper bumper cover. Identifying feature: pin "1 and 2" on the connector.
RS3: the Rear Lid Opener Sensor 2 -G760- must be secured on the lower section for the upper bumper cover. Identifying feature: pin "3 and 4" on the connector.

-- Remove the protective film from the adhesive tape.

-- Press on the power rear lid opening sensor all the way.

Resting time is at least 30 minutes at room temperature.