Overview - Fuel Tank, TDI AWD Vehicles
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 2 Nm
- For the heat shield
- Quantity: 4
- Heat Shield
- For the fuel tank
- Bolt
- 20 Nm +90°
- Always replace after removing
- Fuel Return Line
- From the engine
- Do not kink
- Clipped to the fuel tank
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Supply Line
- To the fuel filter
- Do not kink
- Clipped to the fuel tank
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Line
- For versions with parking/auxiliary heater
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Tank
- Allocation. Refer to the Parts Information.
- Removing and Installing. Refer to FUEL TANK, REMOVING, TDI VEHICLES WITH FWD, WITHOUT HIGH-VOLTAGE SYSTEM .
- Fuel filler neck ground connection for discharging electrostatic charge. Refer to Figure.
- Bolt
- 8 Nm +90°
- Always replace after removing
- Quantity: 2
- Misfueling Guard
- Removing and Installing. Refer to MISFUELING GUARD, REMOVING AND INSTALLING .
- Locking Ring
- For misfueling guard
- Cap
- Turn until it clicks into place.
- Attached to the fuel filler door unit with a fastener
- End Piece
- Push all the way on the connecting piece on the fuel filler neck
- Right Mounting Strap
- Secured to the fuel tank with expanding clips.
- Bolt
- 20 Nm +90°
- Always replace after removing
- Bolt
- 20 Nm +90°
- Always replace after removing
- Left Mounting Strap
- Secured to the fuel tank with expanding clips.
- Bolt
- 20 Nm +90°
- Always replace after removing
- Left Underbody Trim Panel
- Nut: 2 Nm
- Bolt
- 20 Nm +90°
- Always replace after removing
- Right Underbody Trim Panel
- Nut: 2 Nm