EVAP CANISTER, REMOVING AND INSTALLING, WITH Fuel Tank Leak Detection Module -GX36-: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right rear wheel. Refer to the appropriate Service Information .
-- Remove the right rear wheel housing liner. Refer to OVERVIEW - REAR WHEEL HOUSING LINER .
-- Disconnect the connector -1-.
-- Remove the breather lines -2 and 3- from the EVAP Canister.
-- For this, press together the releases. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
-- Remove the bolt -2-.
-- Using a screwdriver, lightly push the retainer -1- toward the luggage compartment in direction of -arrow A-.
-- Pull the EVAP canister downward from the guide bracket and remove in direction of -arrow B-.
-- Remove the EVAP canister.