Wheel Housing Extension, Removing And Installing, Front: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- For reinstallation, mark the installation position of the wheel housing extension on both sides of the fender.
-- Pry out the clips -2-.
-- Carefully warm the adhesive -arrow- using the Wiring Harness Repair Set - Hot Air Blower: VAS1978/14A .
-- Remove the wheel housing extension -1- from the fender.