Wheel Housing Extension, Removing And Installing, Front: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the wheel housing extensions must have reached room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the painted side of the adhesive surface with Cleaning Solution.
-- Remove the protective film from the adhesive tape -2-.
-- Position the wheel housing extension -1- all the way onto the fender edge -3- using the positioning corrugations -arrows-.
-- Press the wheel housing extension to the fender by hand and secure with clamps.
- Resting time approximately 30 minutes at room temperature