Sill Panel Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.
-- Remove the protective film from the adhesive tape -1, 2, and 3-.
-- Position the sill panel trim -4- over the pins on the side sill -arrows-.
-- Press the sill panel trim by hand on the side sill.
- Resting time approximately 30 minutes at room temperature