Fender Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the painted side of the adhesive surface with Cleaning Solution.
-- Remove the protective film from the adhesive tape -2-.
-- Position the trim -1- above the pins -arrows- at the fender.
-- Press the trim to the fender by hand.
- Resting time approximately 30 minutes at room temperature