Rear Axle Toe, Adjusting, Multi-Link Suspension
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
-- Remove lower transverse link to subframe connection nut -1- and loosely install the new nut.
-- Adjust the toe by turning the eccentric bolt -2-.
TIP:
The maximum adjustment range is 90° to left or right of center position.
-- Tighten the nut -1-.
-- After the nut is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK