LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Tire Pressure Monitoring System >> Metal Valve, Removing And Installing >> Metal Valve, Removing And Installing, Version 1 >> Installing

Metal Valve, Removing And Installing, Version 1: Installing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the valve hole.

-- Insert the metal valve into the valve hole, attach the washer and tighten the union nut to tightening specification.

-- Secure the valve using the 2 mm pin against turning.

Fig 1: Securing Against Turning With Counter Hold
GWWA44-0085Courtesy of AUDI OF AMERICA, LLC

-- Install the tire pressure monitoring sensor.

scientia non olet · About LEMON Manuals