Left And Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal while noting the following:

Replace the seal after removal.
The ring groove -arrow- for the gasket and the parking brake motor contact surface must not be damaged.

-- Clean the parking brake motor ring groove and contact surface.

-- Coat the new seal -1- thin with Lithium Grease and install.

-- Completely grease the Torx insert on the parking brake motor drive axle.

-- Slightly turn back the input shaft using the Socket: T10621 -item A- until the parking brake motor can be positioned correctly.

Courtesy of AUDI OF AMERICA, LLC

Do not remove the gasket -1- when assembling the parking brake motor.

-- Rotate the parking brake motor until the bolt and threads are aligned.

The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.

-- Tighten the bolt -arrows- to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -1-.

-- Perform the basic setting of the electromechanical parking brake using the Vehicle Diagnostic Tester.

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.