Brake Pads, Removing And Installing, Pr Number 1LC, 1LG And 1LJ: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Label the brake pads when removing if they are going to be used again. Install in the same position, otherwise the braking effect will be uneven.
-- Remove the affected front wheel. Refer to the appropriate Service Information .
-- Remove the bolts -arrows- by counterholding at the guide pins -1 and 2-.
-- Remove the brake caliper.
CAUTION:
There is a risk of damaging the brake hose due to the weight of the brake caliper.
- Never let the brake caliper hang on the brake hose.
-- Hang the brake caliper using a suitable wire.
CAUTION:
There is a risk of damaging the brake caliper piston if handled incorrectly.
- Never activate the brakes if the brake caliper is removed.
-- Disconnect the connector -arrow- for the brake pad wear indicator contact from the right brake caliper.
-- Remove the brake pads -2 and 3- from the brake carrier -4- -arrows- to do so unclip the brake pad retaining plates.