Mounting Bracket, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Bring the mounting bracket with the installed brake pedal into the installation position.
- Make sure that the wire for the accelerator pedal module is not pinched when inserting the mounting bracket.
- Make sure that the mounting bracket sits in all stud bolts.
-- Tighten the mounting bracket bolts to the required tightening specification. Refer to Figure.
-- Attach the universal joint to the steering gear. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Attach the brake pedal to the brake booster. Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .
-- Install the crash bolster. Refer to CRASH BOLSTER, REMOVING AND INSTALLING .
CAUTION:
Faulty brakes increase the risk of an accident.
- Make sure the brakes are working correctly before driving the vehicle for the first time.