Right Seal, Replacing, Fwd Vehicles: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Coat the outer edge and sealing lips on the new seal with transmission fluid.
- Installation position: open side of the seal faces the transmission.
-- Immediately mount the seal by hand and push it in as far as possible so that it is secure in the transmission housing.
-- Drive in the seal all the way using the Thrust Piece: T40372 ; do not tilt the seal while doing so.
-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Check the transmission fluid level land fill. Refer to TRANSMISSION FLUID LEVEL, CHECKING .