Bevel Box, Tightening Specification
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Bevel Box on Dual-Clutch Transmission - Tightening Specification
- Replace the bolts after removing them.
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -arrows- | Install all the way by hand |
| 2. | -arrows- | 40 Nm diagonally |
| 3. | -arrows- | 90° additional turn, diagonally |
Bevel Box Bracket - Tightening Specification and Sequence
-- Tighten the bolts in steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 and 2- | Install all the way by hand |
| 2. | -1- | 8 Nm |
| 3. | -2- | 8 Nm |
| 4. | -1- | 40 Nm |
| 5. | -2- | 40 Nm |