Overview - Assembly Mounts

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Assembly Mounts

Courtesy of AUDI OF AMERICA, LLC

1 - Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
2 - Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
3 - Bracket
- Equipped on some models
4 - Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
5 - Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
6, 7 - Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
8 - Ground Wire
9 - Nut
- Tightening Specification. Refer to the appropriate Wiring Diagram.
10 - Bolt
- Tightening specification. Refer to OVERVIEW - ASSEMBLY MOUNTS
11 - Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
12 - Bolt
- 130 Nm +90°
- Replace after removing
13, 14 - Bolt
- 60 Nm +90°
- Replace after removing
15 - Bolt
- 60 Nm +90°
- Replace after removing
16 - Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
17 - Bolt
- 50 Nm +90°
- Replace after removing