Glass Panel Seal, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The following components must be replaced after removal. Refer to the appropriate service information .

Special tools and workshop equipment required

Wiring Harness Repair Set - Hot Air Blower :VAS1978/14A

Fig 1: Hot Air Blower VAG1416
Courtesy of AUDI OF AMERICA, LLC
Lever - Fuel Line :T10468

Fig 2: Identifying Lever - Fuel Line
Courtesy of AUDI OF AMERICA, LLC
Cleaning Solution :D 009 401 04
Bonding Agent :D 355 205 A2

Removing

-- Open the glass panel far enough until it is lifted at the front and rear.

-- Mark the position of the seal for the glass panel on the glass panel.

-- Loosen the glass panel seal with the Lever - Fuel Line :T10468 and remove it.

-- Remove the glass panel seal. If necessary, also warm it up using the Wiring Harness Repair Set - Hot Air Blower :VAS 1978/14A .