Sunroof Control Module -J245-, PROGRAMMING
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
If the Power Sunroof Control Module -J245- was replaced, it must be activated after installing.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Diagnostic-capable systems
- 00CA - Sunroof Control Module J245
- 00CA - Sunroof Control Module J245 Functions
- 00CA - Replace the control module
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.