Glass Trim, Removing And Installing, A6: Notes

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The following components must be replaced after removal. Refer to OVERVIEW - SLIDING SUNROOF .
Pay attention to the repair information. Refer to REPAIR INFORMATION .
Required Tools and Materials for Removal and Installation. Refer to REQUIRED TOOLS AND MATERIALS FOR REMOVAL AND INSTALLATION .
The vehicle and the glass trims must be at room temperature.

Special tools and workshop equipment required

Double Suction Lifter :V.A.G 1344

Fig 1: Double Suction Lifter
Courtesy of AUDI OF AMERICA, LLC
Wedge Set :T10383

Fig 2: Identifying Wedge Set
Courtesy of AUDI OF AMERICA, LLC

Preparing the Tool:

Courtesy of AUDI OF AMERICA, LLC

-- Create a tool from a long welding wire by bending the front end to make the smallest possible eye -arrow A-.

-- Bend the back end to avoid poking injuries -arrow B-.