Sunroof Frame Without Damage, Preparing For Installation

• The vehicle must be at room temperature.
• The adhesive bead must be free of dirt and grease.
• Cut the adhesive bead back/evenly just before installing, but do not completely remove.
• Do not prime or use a cleaning solution on the adhesive bead.

-- Cut the rest of the adhesive on the flange using the Window Cutter :V.A.G 1561 A  and Window Cutter - Scraper (25 mm) :V.A.G 1561/8  or using a scraper from the Scraper Set :VAS 861 005  so that it is even just before installing, but do not remove it completely.

TIP:

The residue acts as a base for the adhesive to be applied.

• If bonding is not performed immediately after the cutting back the adhesive on the flange, the remaining material must be activated with the Activator for Pre-Coated Windows :D 181 802 M1  . Flash-off time: 10 minutes
• If the body flange was damaged, repaired or replaced, the paint structure must be repaired and if necessary, the corrosion protection measures must be performed. Refer to Audi Paint Handbook. Clean the repaired area with Cleaning Solution :D 009 401 04  , let it dry and then apply the Primer :D 009 200 02  . Flash-off time: 10 minutes

-- Apply the adhesive. Refer to Adhesive Application: .