Cam Actuator, Removing And Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Cylinder Bank 1 (Right) Cam Actuator, Removing

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

Cylinder Bank 2 (Left) Cam Actuator, Removing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Engine Control Module -J623-. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

-- Remove the connectors -3 and 4- from the bracket and free up the wire.

-- Free up the wiring harness -1-.

-- Remove the bolts -arrows- and then remove the bracket -2- for the engine/motor control module.

Continuation for Both Sides:

All additional procedures are described. Refer to CAMSHAFT, REMOVING AND INSTALLING .

Installing

Additional procedures:

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

Tightening Specifications

Refer to OVERVIEW - ENGINE CONTROL MODULE