HYDRAULIC PULSE MEMORY WITH Accumulator Solenoid -N485-, EMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
-- Move the transmission into the "P" position.
-- Switch the ignition off.
-- Remove the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Remove the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
CAUTION:
Risk of destroying due to electrostatic charge.
- Do not touch the connector terminals.
- Touch a grounded object (for example the hoist) and discharge any static electricity.
-- Disconnect the connector -B- for the hydraulic pulse memory -A- carefully.
-- Remove the bolts in the sequence -3 to 1-.
-- Remove the hydraulic pulse memory -A-.