HYDRAULIC PULSE MEMORY WITH Accumulator Solenoid -N485-, EMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the O-ring and bolts for the hydraulic pulse memory.
-- Install the hydraulic pulse memory -A- with a new O-ring -D-.
-- Tighten the bolt in the following sequence: -1 to 3-.
- -1- : M6x59
- -2 and 3- : M6x20
-- Connect the connector -B- and engage them.
-- Route the wire -C- according to the illustration and secure it -arrows-.
-- Install the ATF filter. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .
-- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
-- Fill the ATF. Refer to ATF, DRAINING AND FILLING .