Carpet, Removing And Installing: Removing
-- Remove the front seats. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the center console. Refer to Center Console, Removing and Installing .
-- Remove the A-pillar lower trim panels. Refer to A-Pillar Lower Trim Panel, Removing and Installing .
LHD vehicle
-- Remove the footrest. Refer to FOOTREST, REMOVING AND INSTALLING, LHD VEHICLES .
Continuation for all vehicles
-- Remove the footwell cover on the driver side. Refer to DRIVER SIDE FOOTWELL COVER, REMOVING AND INSTALLING .
-- Remove the B-pillar lower trim panels. Refer to B-Pillar Lower Trim Panel, Removing and Installing .
-- Remove the floor mats.
-- If installed, remove the crash pads -D-, -F- and disconnect the connectors -A-.
-- Pivot the rear air duct -C- upward -arrow E- and out of the catch -arrow B-.
-- Remove the rear air duct.
-- Remove the lower child seat anchor guide. Refer to LOWER CHILD SEAT ANCHOR GUIDE, REMOVING AND INSTALLING .
-- Grab the rear bench seat -1- under the molded part using both hands on one side.
-- Using both hands on one side, forcefully pull the rear bench seat -1- upward -arrow A- to release the molded part from the front mount.
-- Repeat the procedure in the center -arrow B- and on the opposite side of the rear bench seat -arrow C-.
-- Lift the front rear bench seat -1- and pull the rear carpet forward.
-- Remove the carpet -1- from under the sill panel.
-- Lift the carpet -1- at the rear -A arrows- and pull it toward the rear -B arrows-.
Conditions
- Make sure the carpet does not tear at the openings.
-- Fold floor covering and remove through the door.