Sun Visor, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Unclip the sun visor mount expanding cap -1- in the direction of -arrow- by sliding the Angled Screwdriver :VAS 6416 just approximately 1 mm under the cap.
TIP:
If the long reach special wrench is inserted farther, it will be located under the sun visor mount. It is then not possible to pry out the expanding cap.
-- Disengage the sun visor from the center bearing.
-- Unclip the sun visor mount -1- with the clamp -2- downward in the direction of -arrow- from the opening in the body and remove it.
-- Disconnect the connector and remove the sun visor.