Seat Position Sensor, Removing And Installing: Removing

-- Disconnect the modular wiring routing. Refer to the appropriate service information .

-- Open the corrugated tube, remove the wire for the Driver Seat Position Sensor -G553- / Front Passenger Seat Position Sensor -G554- with the connector, and free it up.

-- Remove the cable ties or cable clips for the wire on the seat pan lower frame.

-- Remove the bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Unclip and disengage the seat position sensor -1- for the seat pan lower frame -3- -arrow-.

-- Free up and disconnect the connector -3- to the seat belt latch.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the seat position sensor -1- with the wires -2-.

Front passenger seat, Rest of World market versions

-- Disconnect the connector -2- on the Front Passenger Occupant Detection Sensor -G128- -1-.

Courtesy of AUDI OF AMERICA, LLC

Continuation for all vehicles

Front passenger seat, North America market versions

-- Disconnect the connector -2- on the control module

Fig 1: Passenger Occupant Detection System Control Module -J706-

Courtesy of AUDI OF AMERICA, LLC

Continuation for all vehicles