Seat Position Sensor, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Hook the bracket -2- into the upper seat rail and clip it in.
-- Slide the seat position sensor -4- on the bracket and position at a distance -a- = 4.0 mm to the lower seat rail -1-.
-- To do this, position the Gauge - Gap Adjustment:3371 / 4 mm or Gauge - Eos Roof:VAS 6448 / 4 mm between the seat position sensor and the lower seat rail and tighten the screw -3-.
Conditions
- Check the seat position sensor with the => Vehicle Diagnostic Tester .