Seat Occupant Detection System, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Conditions

Make sure the connectors are pushed in all the way and that they engage audibly.

If the control module is replaced, the test plan to replace the control module must be performed.

-- Perform the "Control Module, Seat Occupant Detection System, Basic Setting" using the => Vehicle Diagnostic Tester . Refer to DIAGNOSTIC ENTRIES .

Continuation