Outer Rear Three-Point Seat Belt, Removing And Installing, A6 Sedan: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
Conditions
- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
- Make sure the connectors are pushed in all the way and that they engage audibly.
- If equipped, after replacing the Left Rear Seat Belt Tensioner Control Module -J1097- /Right Rear Seat Belt Tensioner Control Module -J1098-, the control module must be adapted using the => Vehicle Diagnostic Tester .
-- Insert the three-point seat belt -1- with the anti-twist mechanism and bolt -2- into the mount -3-.
-- Push the three-point seat belt all the way forward -arrow- and tighten the bolt at the same time.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .