Pressure Hose Sensor For Front Pedestrian Protection G579, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Engage the pedestrian protection crash sensor -1- into the molded foam part -3-.

Conditions

Do not kink or turn the pressure hose -2-.
The pressure hose -2- must be inserted without any tension.

-- Install the molded foam part with the pedestrian protection crash sensor. Refer to Front Bumper .

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Attach the connector -1- to the crash sensor until it clicks into place -arrow-.

Fig 1: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

-- Push in the connector lock -2- to secure the connector.

Conditions

Make sure the wires are not pinched.

CAUTION:

Pyrotechnical components can deploy unexpectedly.

A risk of injury is possible.

- Keep as far away as possible from the pyrotechnic component when switching the ignition on.

-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .