Pedestrian Protection Trigger 1 And 2 G598/ G599, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
-- Remove the rear fender cover. Refer to OVERVIEW - FENDER .
-- Front passenger side: remove the expanding rivets -1-.
-- Tilt the rain water drain channel -2- upward and remove from the fresh air intake -3-.
-- Remove the clip -3-.
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Free up the connector -2- and disconnect.
-- Remove the bolt -1-.
-- Disengage the pedestrian protection trigger -4- on the hood hinge and remove.