Knee Airbag With Igniter, Removing And Installing, Front Passenger Side: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Install the glove compartment. Refer to Glove Compartment, Removing and Installing .

Tip

After completing a procedure, perform a visual inspection to make sure that the surface of the knee airbag is not damaged.

Conditions

Make sure the wires are not pinched.

CAUTION:

Pyrotechnical components can deploy unexpectedly.

A risk of injury is possible.

- Keep as far away as possible from the pyrotechnic component when switching the ignition on.

-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .