Airbag Control Module J234, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Conditions

Make sure the connectors are pushed in all the way and that they engage audibly.

CAUTION:

Pyrotechnical components can deploy unexpectedly.

A risk of injury is possible.

- Keep as far away as possible from the pyrotechnic component when switching the ignition on.

-- Connect the battery ground cable. Refer to BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITHOUT ALTERNATIVE DRIVE SYSTEM, (0K0) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH HIGH-VOLTAGE SYSTEM, (0K3) , or BATTERY A, DISCONNECTING AND CONNECTING, VEHICLES WITH ALTERNATIVE DRIVE SYSTEM, (0K4) .

If the control module is removed and installed, perform the test plan for installing the control module.

-- Perform the function "Inertial sensor basic setting" using => Vehicle Diagnostic Tester . Refer to the DIAGNOSTIC ENTRIES .

Continuation