Rain/Light Recognition Sensor G397, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the interior rearview mirror. Refer to INTERIOR REARVIEW MIRROR, REMOVING AND INSTALLING .

-- Disconnect the connector -3-.

Fig 1: Locating Screwdriver

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainers on the spring -2- using a narrow screwdriver -5- -arrows-.

-- Wait one minute so that the silicone pad can be removed without leaving any residue.

-- Loosen the Rain/Light Recognition Sensor -G397- by moving it back and forth.

-- Remove the sensor, at the same time do not touch the humidity sensor -arrow-.

Fig 2: Locating Rain/Light Recognition Sensor

Courtesy of AUDI OF AMERICA, LLC