Rear Body Acceleration Sensor -G343-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bench seats. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .
-- Equipped on some models: remove the left side cushion. Refer to OVERVIEW - COVER AND CUSHION .
-- Equipped on some models: remove the lower C-pillar trim. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Disconnect the connector -1-.
-- Remove the bolt -2- and remove the body acceleration sensor -3-.