Front Wheel Camber, Adjusting
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Camber is adjusted by repositioning the suspension strut using the slots in the strut bearing (vehicle resting on wheels).
-- Remove cover.
-- Loosen mounting nuts (arrows).
-- Reposition suspension strut in slotted holes.
-- Tighten mounting nuts.
-- Check camber value again and correct if necessary.
-- Check toe, adjust if necessary