Release Button In Rear Lid Handle E234, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Vehicles with rearview camera

If the Release Button in Rear Lid Handle -E234- was replaced, then complete the test plan for replacing the control module:

-- Complete the "Replace control module" function using the => Vehicle Diagnostic Tester . Refer to DIAGNOSTIC ENTRIES .

Continuation

-- Refer to REARVIEW CAMERA SYSTEM, CALIBRATING .

Continuation for all vehicles

Vehicles with peripheral camera

-- Refer to PERIPHERAL CAMERA, CALIBRATING .