Overview - Rear Lid Tail Lamps

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Rear Lid Tail Lamps, A6

Courtesy of AUDI OF AMERICA, LLC

Left Tail Lamp 2 -MX5-
- Refer to Rear Lid Tail Lamp, Removing and Installing .
- Refer to TAIL LAMP, CORRECTING INSTALLATION POSITION, A6 .
Seal
Cover
- Refer to Rear Lid Tail Lamp, Removing and Installing .
Nut
- Quantity: 3
- Refer to Fig 2
Grommet
Left License Plate Lamp -X4-
- Refer to Left and Right License Plate Lamp X4/X5, Removing and Installing .
Right License Plate Lamp -X5-
- Refer to Left and Right License Plate Lamp X4/X5, Removing and Installing .
Grommet
Nut
- Quantity: 3
- Refer to Fig 2
Cover
- Refer to Rear Lid Tail Lamp, Removing and Installing .
Seal
Right Tail Lamp 2 -MX6-
- Refer to Rear Lid Tail Lamp, Removing and Installing .
- Refer to TAIL LAMP, CORRECTING INSTALLATION POSITION, A6 .
Tail Lamp Trim Molding
- Refer to OVERVIEW - TRIM MOLDING .

Tightening specification and sequence for the tail lamps

Fig 2: Tail Lamp Tightening Sequence (A6)

Courtesy of AUDI OF AMERICA, LLC

Step	Nuts	Tightening Specification
1.	-1- through -3-	Install all the way by hand
2.	-1- through -3-	3.5 Nm