Rear Lid Motor 1 And 2 -V444- / -V445-, Removing And Installing, A6 AVANT: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the D-pillar trim panel. Refer to the appropriate service information .
-- Push the expanding pin -4- through.
-- Release the retainers -1 and 5- and remove the wiring harness bracket -3- from the mount on the hinge -2-.
-- Disconnect the connector -5-.
-- Remove the bolt -2- and the nut -1-.
-- Remove the rear lid motor -4- from the mount on the hinge -3-.