Rear Lid Motor 1 -V444-, REMOVING AND INSTALLING, A6 SEDAN: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- First tighten the bracket to the rear lid motor at the hinge and then press on to the ball pin on the body.
-- Perform an adaptation. Refer to REAR LID DRIVE UNITS -V444- / - V445- / -VX69- / -VX77-, ADAPTING .