Rear Lid Closing Aid Motor -V382-, REMOVING AND INSTALLING, A6 AVANT AND A7 SPORTBACK: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear lid lower trim panel. Refer to the appropriate service information .
-- Disengage the support bracket -7- by releasing the catches in direction of -A arrows-.
-- Disengage the release cable nipple -6- from the release lever -5-.
-- Disconnect the connector -3-.
-- Release the catches -2, 4 and 8- by turning them 90° clockwise in direction of -arrow B-.
-- Remove the Rear Lid Closing Assist Motor -V382- -1-.