Power Rear Lid Opening Sensor 2 -G760-, REMOVING AND INSTALLING, A6 VERSION 2: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, A6 .
-- Free up the connector -2- and disconnect it.
-- Warm the adhesive using the Wiring Harness Repair Set - Hot Air Blower :VAS 1978/14A .
-- Pull off the power rear lid opening sensor 2 -1- in direction of -arrows- and remove.