Power Rear Lid Opening Sensor 2 -G760-, REMOVING AND INSTALLING, A6 VERSION 2: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the power rear lid opening sensor must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove adhesive residue from the bumper cover.
-- Clean the plastic side of the adhesive surface with Cleaning Solution :D 009 401 04 and let dry.
-- Align the power rear lid opening sensor 2 -3- to the marking in the bumper cover -2-.
-- Remove the protective film from the adhesive tape -1-.
-- Press on the power rear lid opening sensor 2 all the way.
- Resting time is at least 30 minutes at room temperature.