Power Rear Lid Opening Sensor -G750-, REMOVING AND INSTALLING, A6 VERSION 2: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the nuts/bolt -arrows- on the lower section of the bumper cover.
-- Remove the power rear lid opening control module. Refer to Rear Lid Opener Control Module -J938-, REMOVING AND INSTALLING .
-- Disconnect the connector -2-.
-- Remove the sensor -1- from the mounts.
-- Remove the sensor.